brushless pictures

[Jamesd]

Hi

I have a standard lazer and I have fitted my new brushless in and am having trouble fitting it in the car as the wires are too long to go under the body but it will be hard to shorten them

Could people give me advice and could you post some pictures up of your lazer's.

Thanks

[Fabs]

I guess we'd all reply that we have the wires as short as possible...

[Jamesd]

I know that, I want to see what way people have got there speedo's

[burgie]

I have an LRP SPhere in my Lazer, with the solder tabs of the ESC facing the motor. I then cut the wires as short as possible (!) to suit the fitment. :thumbsup:

[paulc]

get another body shell but don't cut it to the lines where it shows too cut it as low as possible around the bottom then the body will sit higher leaving plenty of room for wires :thumbsup:

paul

[DanW]

if you have the motor tabs pointing towards the side of the car you should then have space to allow a bit of a loop in your wires if your cautious about cutting them on the short side.

[Jamesd]

Hi

Thanks for the suggestions.
I am not getting a new bodyshell has I have just got mine professionaly done, I got the solder tabs facing the outside of the chassis, maybe if I turned the speedo around.

James

[hopsing]

What ESC do you have? And if you can post a pic of how yours is set up now, maybe we can give you a suggestion on how to rearrange it.