zero bump steer with 30deg caster

[flipside]

Hi,

What is the correct setup when you want zero bump steer when using 30deg caster blocks?

Currently I run 2 gold washers at the steering spindle ballstud (outside) and a short neck ball stud at the steering link (inside).

Kind regards,

wouter

[markwilliamson2001]

Sounds about right. I never used to use washers on the inside (bellcranks) end of the link, just two washers at the hub/axle end.

HTH
Mark

[sosidge]

Depends on the axle height too. If in the middle, it should be two 30thou spacers on the spindle, silver ballstuds.

[elvo]

If the spindle is in the middle, and you haven't got loads of washers stacked up under the inner camber link ball, 1 washer ought to do it. Would have been 2 if both ball studs were silver ones.

There's an easy way to check: if the steering link is parallel to the wishbone, it's good.