ANTI ROLL BAR KIT

[Richard saunders]

where can u get a anti roll bar from 4 the x6

[matdodd]

A B4 one can be made to fit although most people just make the bar with piano wire & use fittings they have lying around

[Richard saunders]

i just can not get piano wire anywhere :thumbdown:

[matdodd]

Where you from?

[Richard saunders]

reading m8

[Darren Boyle]

Isnt there a "Hobbystores" in Reading, they will have piano wire......

[Body Paint]

I use a B4 one and all the fittings from the B4 roll bar kit.

You need to take the shock tower off and cut a 1.5 mm slot in the rear bulkhead then drop the ARB into it and bolt the shock tower back on.

[fastinfastout]

does anyone have any pics by any chance?

[jono83]

edit

[YoungChazz]

Some use the Losi 4257 sway bar kit. The little plastic thingys that hold the bar on can be bolted on the back of the tower using the tower mounting bolts. The kit has everything you need except the bar itself (Throw away the included Losi bars.) which you get with piano wire at your LHS.

[matdodd]

If your at the last national let me know and I'll bring you some or as darren said try you lhs most carry it

[Richard saunders]

thanks mat i got some 2day 1.2mm thank u 4 u help

[gazhillAE]

B4 bar kit here!

Pics!!!!

Depending on if you are using the Espeed hangers will depend on whether you mount the roll bar high or low.

you need to try and make sure if possible with the wishbones level that the anti roll bar connected is level aswell.

You will have to cut the small screws down that the ball joints mount to to adjust this so when its connected its level

Make sure that the bar doesnt rub too much on the ball studs when it goes up if at all! RPM ball ends are to thick and will catch from experience so i changed for JConcepts ends!

As per my pics!

[Body Paint]

That's perfect is that Gaz :thumbsup:

[gazhillAE]

That's perfect is that Gaz :thumbsup:

Why thank you Sir :thumbsup: