Castle Mamba Monster ESC problem

[hockeyhead019]

hey guys

ok so i finally got everything set and was ready to calibrate my esc like it says to... connected the batteries and held the trigger down and hit the switch... nothing happened :( i have power because i have steering but the esc won't make any noises or light up or anything... any help would be greatly appreciated... thanks

-Jim

[stampede vxlboy]

turn the wires the right way i got a mamba castle i can set it to any control have you put the wires wrong way around servo i can set it to any control but if there just turn the front wheels turn the little black tab around and it should work if not use you pc to set :thumbsup:
turn it on but hit the red switch at the same time as turning it on . if not the lights will just flash .?
pull the handset back turn it on at the same time press the red button and lift off

[Marvin]

hey guys

ok so i finally got everything set and was ready to calibrate my esc like it says to... connected the batteries and held the trigger down and hit the switch... nothing happened :( i have power because i have steering but the esc won't make any noises or light up or anything... any help would be greatly appreciated... thanks

-Jim

Definately wired up the correct way round? Is your throttle on your radio reversed? If it is (except on Futaba) then it needs to be the 'normal' way round. Make sure your throttle trim is neutral too.

If that all fails, then it looks like it'll have to go back to Castle Creations. Send them an email to see if they come up with anything.

[hockeyhead019]

if my wiring was backwards y do i still have power to the steering servo? i would think that if i was backwards then the power wouldn't work... so i'm inclined to think that i have it wired correctly as it matches the orientation of my steering servo... however i missed the part about having your controller reversed so i'll check that out... thanks guys

[Marvin]

Oh, must have missed the bit about the steering servo still working. Try the radio re-calibration, and if that fails, get onto Castle Creations, it may need to go back. Don't worry though, they have excellent service.

[hockeyhead019]

thats exactly where i went... castle's help was great... apparently i had a bad controller :( it happens though and their going to ship me a new one tomorrow and all i have to do is send the defective on back to them

castle's customer service gets two thumbs up and more if i had them haha