View Full Version : How to flip transmision on MI4?
Kirby
01-12-2009, 10:49 PM
Hey just got my Schumacher MI4 today and was wondering if anyone has a guide to flipping the transmision for lipos ( spur gear on battery side enabling you to put electronics closer to centre of car ) Would be much appreciated :)
Isn't that what the new MI4LP for?
Kirby
01-12-2009, 10:58 PM
Isn't that what the new MI4LP for?
On the MI4-LP it is already done for you but alot of people have done it on the original MI4's.
Well, at a guess, you would need to turn your layshaft round, and flip your rear diff halves over, but keep the diff screw on the same side as it is now, whether that is possible, I don't know.
BagofSkill
01-12-2009, 11:20 PM
I think you can just flip the diff over without changing the diff screw, as long as the grub screw is in and tight. Unless they've changed the design... That's all I did on my 3.5 and I never had any diff loosening issues.
Kirby
01-12-2009, 11:23 PM
im still quite confused on how to do it LOL
This is a very new car to me and ive only ever had Xrays before.
Hopefully someone has a proper guide.
lochness42
02-12-2009, 06:32 AM
Simple job - flip spur 180degrees - layshaft isn't needed to flip - it's just easier to take it out from other side. Then flip diff 180degrees - as mentioned be sure that grub screw is tight inside. Don't forget about rear belt - it has to be in new position now.
I'll try to make some photos of my car tonight, if you want.
Kirby
02-12-2009, 07:09 AM
Simple job - flip spur 180degrees - layshaft isn't needed to flip - it's just easier to take it out from other side. Then flip diff 180degrees - as mentioned be sure that grub screw is tight inside. Don't forget about rear belt - it has to be in new position now.
I'll try to make some photos of my car tonight, if you want.
Where is the grub screw?
Got a pic if you have done it?
lochness42
02-12-2009, 09:53 PM
Where is the grub screw?
Got a pic if you have done it?
here are some photos http://picasaweb.google.com/lochness42/Mi4FlippedDrivetrain?feat=directlink
Grub screw is from other side as screw is in diff - it's there to avoid loosening diff.
Dazzler
02-12-2009, 10:42 PM
I'm liking the thermometer tape on the motor clamp... Seems like a good idea. (I presume that is what it is)
lochness42
03-12-2009, 08:34 AM
Yes it is
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.