Rounded Pinion Grub Screw

[Kirby]

Hey guys.

Was taking all the electrics out of my T2009 to go into my Mi4 when i realised that the grub screw in the pinion is completley rounded :(

If anyone knows how to get this or have experienced this please help me out. A Dremel is not an option as dont want to be paying cash to get one.

Please reasure i dont need to buy a new motor :(

[discostu]

use a pair of side cutters and carefully leaver the pinon of the shaft the grub screw should loosen up once its off if not throw the pinon away its cheaper than a motor

[Kirby]

I have tried this and it wont budge :(

[mark christopher]

buy a pinion puller
http://www.fastrax-rc.com/rc-products.php?productId=0000001878&cat=ST

[jon kedge]

Try this,it might sound brutal but iv'e had to do it over the years.

Use a pair of pliers that can fit around the shaft without clamping on the shaft when closed and get someone to hold the pliers and the motor in there hands to absorb the punch,use a long 3mm cap head screw as this is slightly smaller than the 1/8th rotor shaft and slowly with the use of a hammer knock the shaft through the pinion,it will work,be carefull not to drop the motor and watch your fingers.

[Kirby]

use a pair of side cutters and carefully leaver the pinon of the shaft the grub screw should loosen up once its off if not throw the pinon away its cheaper than a motor

Try this,it might sound brutal but iv'e had to do it over the years.

Use a pair of pliers that can fit around the shaft without clamping on the shaft when closed and get someone to hold the pliers and the motor in there hands to absorb the punch,use a long 3mm cap head screw as this is slightly smaller than the 1/8th rotor shaft and slowly with the use of a hammer knock the shaft through the pinion,it will work,be carefull not to drop the motor and watch your fingers.

Pinion now off and motor is good to use again :D

Thanks :thumbsup:

[i4n]

There's am Imperial size just a bit bigger than 1.5mm (1/16th I think) that you can jam in when you round a 1.5mm off.

It's got me out of a pickle a few times.

Ian