PDA

View Full Version : Xx4 brushless

rob84
14-12-2009, 08:27 PM
Looking for a decent brushless system which is easy to install in a xx4 without modifaction. can anyone help?
mikeyscott
14-12-2009, 08:30 PM
Looking for a decent brushless system which is easy to install in a xx4 without modifaction. can anyone help?

Tekin RS? Mate is getting one for his Losi XX4

I have one in my Cat SX and it's got a tiny footprint
rob84
14-12-2009, 08:46 PM
does the tekin not over heat though?
Ferret
14-12-2009, 09:18 PM
I'm running a Mamba Max controller in my XX4. I've ran it successfully both with a castle creations 4600kv motor and a Tekin 448 motor.

No modifications were required, but I am using LiPo stick packs, not saddle packs.

Avner.
mikeyscott
14-12-2009, 09:41 PM
does the tekin not over heat though?

Nope never had a problem. It does get warm

Got one in my XXCR too which has no problems

What motor are you thinking of putting in?
coolcars782
14-12-2009, 09:44 PM
always ran novak gtb and velocity
rcdunk
15-12-2009, 11:41 AM
losi xcelorin in mine at the moment but have also had a speed passion and lrp sphere in it too
Oliv996
15-12-2009, 12:42 PM
Yes the RSpro has an narrow footprint and fit well into XX4. With 6.5T motor it will run without fan and that's a good point for your bodyshell :woot:
Garry Spice
15-12-2009, 12:50 PM
i had a LRP tc in my xx4 and it worked a treat,but make sure esc is pushed right back tho or the fan rubs the shell and sound like a swarm of bee's!
caciqueconnection
16-12-2009, 11:24 AM
I'm using a Mamba Max in mine and fitting was made with ease. Saddle pack used.

There are 3 configs available:

Stick LiPo:
No room problem at all, except height if fan required (but you can mill 3mm off the heatshink).

Saddle LiPo (using Rx plate)
Same as sticks.

Saddle LiPo (without Rx plate)
With small Rx and ESC this config doesn't generate too much room problems. But when Rx or ESC aren't the smallest fitting becomes almost a nightmare.

Height, as always will be a bit of a problem.

I only recommend this one if imposibble to fit your LiPo's under the receiver tray or if you want to place brass weight under the batts.

In my case (no plate) With Mamba and Sanwa 411 fitted vertically it works. But packs only have 4-5 mm of adjust.

the Tekin RS-Pro is propably the one with the smaller footprint...and good stuff too.