PDA

View Full Version : lrp sxx tc issue


Panic
17-12-2009, 05:38 AM
Hey guys, need your input,,,bought an LRP SXX TC speedo from a guy... Steering works fine but no throttle. LED status indicates its working - .I have Re-setup the ESC, no results. I noticed though that motor do not Beep anymore when entering setup!... Changed motor,changed sensor wire - but still no throttle, All motors work well with other ESC's and my wiring is properly connected...any ideas? is the esc useless? or i m doing something wrong?

Tnx

Big G
17-12-2009, 10:13 AM
if you spin the motor while holding the throttle on (or push the trim up) does it start spinning and will rev? does it work at all with the sensor wire disconnected?

mine went like that were it wouldn't go from a standstill, but with a rolling start it would drive. I had to return it for repair. a problem with the sensor circuit.

TonyM
17-12-2009, 02:14 PM
I had exactly the same issue with my SXX TC. It turned out to be the sensor cable, which seems to fit rather loosely in the SXX socket and although it looked as though it was fully pushed in it wasn't. I now run with a small bit of BluTack covering the sensor plug and ESC socket and so far this has stopped the lead becoming loose.

Mike Hudson
17-12-2009, 03:47 PM
I had exactly the same issue with my SXX TC. It turned out to be the sensor cable, which seems to fit rather loosely in the SXX socket and although it looked as though it was fully pushed in it wasn't. I now run with a small bit of BluTack covering the sensor plug and ESC socket and so far this has stopped the lead becoming loose.

It may appear loose, I thought this too when I got mine as the sensor lead kept coming out but you need to give it quite a good push to 'click' it in then it is a very good tight fit! Not had a problem since :)