PDA

View Full Version : Kyosho ZX- 5 conversion


KBRacing
17-05-2007, 08:57 PM
:wtf: What conversion is better the KM Concepts conversion or the ATOMIC CARBON - Ion Spec Carbon Fibre Chassis is better for my Kyosho ZX-5 .... ????

bert digler
17-05-2007, 08:59 PM
:wtf: What conversion is better the KM Concepts conversion or the ATOMIC CARBON - Ion Spec Carbon Fibre Chassis is better for my Kyosho ZX-5 .... ????


atomic for quality km for handling go km

Hog
18-05-2007, 07:49 AM
I went the KMC route after a bout of interference put me into a wall and snapped the original chassis in half.........:mad:

Certainly transformed the car indoors - I race on a polished wooden floor and with the kit chassis I used to get understeer one way, oversteer the other. Now I know I have equal handling side to side which means no nasty surprises when I give it the beans - at least - it will when I get my motor and cells sorted.......:yawn:

I've only raced once outside since the conversion and it was very easy to drive - even on my indoor setup 'cos I ran out of time to swap over. I never ran the kit setup outside so couldn't comment on a comparison.

So for me it's KMC - cost me $178 (£92) including shipping and the extra rear layshaft kit you have to buy to get the drive cup.

omen1975
19-05-2007, 01:04 PM
KM all the way for me too, never looked back.

omen1975