Brushed help?????

[ashleyb4]

A few weeks before the indoor finals i ran my 14x2 in my xx4 and it was undereared and it got very hot it worked find afterwards but then the night before the indoor finals i tried it and there was a little puff of smoke come out of the motor and it stoped working. So thought poo have to buy another motor so i did but it was a bit quick so i wanted to try my 14 so i got my motor skimmed(thanks damo and stu) and i put it in my brand new 10x1 can and it went very very very slowly so i thought oh sticky brush someting simple. Then i tried it again after a bit of fiderling and it did it again so i just bunged the 10 back in and put the 14 back in my box and thought nothing of it. SO now i thought ill have a look into the problem. But i cant find anythign wrong with the armature. What can it be the can is fine as i ran my 10x1 armature in it fine but the 14 wont work??????

A

P.S.Help!!!!!!!

[RLGfx]

sounds to me like a dead segment on the armature... are any of the copper wires on the arm blackened? If so that's the problem...

[ashleyb4]

Ok i tried it in another can and it worked fine on the run in on my charger the when i put it down on the drive to test it it went ok but it was a bit slow but i thought it was my cells as they where a uncharged pack. Then it started to need a nudge to get going. Then i nudged it once and it started going properly i was going bloody quick and didnt need a nudge and i thought cool sorted. Spoke to soon.:D Then it stopped completely then hasnt worked since.

A

[bert digler]

Ok i tried it in another can and it worked fine on the run in on my charger the when i put it down on the drive to test it it went ok but it was a bit slow but i thought it was my cells as they where a uncharged pack. Then it started to need a nudge to get going. Then i nudged it once and it started going properly i was going bloody quick and didnt need a nudge and i thought cool sorted. Spoke to soon.:D Then it stopped completely then hasnt worked since.

A

ash its shagged

[Northy]

sounds like you could have shorted some of the windings out, if the insulation has burnt through on some they will short. Sounds like arm is a parrot. :D :D

G

[ashleyb4]

ive got a spare 12x2 armature in my box its skimmed so i will chuck it in the can the circuit board wasnt fried the can i fine.

A