PDA

View Full Version : Trf501x ball diff


kustom chris
27-01-2010, 06:02 AM
Is there any reason I shouldn't put the diff balls in the inside holes cause the diff balls are on the very edge of the diff plate anyone tried the inside before ?cheers chris

jhammond
27-01-2010, 07:58 AM
Just don't do it.

There's a few reasons why you shouldn't; I think they've been covered in the Tamiya forum before. Quick search should do the job.

:thumbsup:

T4miy4 Guy
27-01-2010, 08:19 AM
Those holes on the inside are for the front one way screws i do believe

Andy

Welshy40
27-01-2010, 08:43 AM
do a search on diffs on the Tamiya forum. Several people have stated (me included) that if you buy more balls for the diff and add to the inner holes (so all diff holes are filled inner and outer) you will make a smoother diff and also improve the efficiency so less rebuilds.

Jimmy did state somewhere why you shouldnt use the inner hole but nothing relating to why you shouldnt use both.

T4miy4 Guy
27-01-2010, 08:57 AM
I found this thread (i made a thread but can`t find it)
http://www.oople.com/forums/showthread.php?t=16310&highlight=pulley+holes

I tried this (adding extra balls) also so, it didn`t feel right to me either so i took them out.

Andy

Welshy40
27-01-2010, 10:34 AM
Andy

Ok now I see where your coming from and yes I forgot about that - sorry.

I found that as the diff screw in the 501 was so thin that I had the same funny feeling on the diffs when I added the balls so I ended up adding a kyosho screw, thrust race and nut and that resolved the weird feeling, but then again my car was a bit weird so could have been a one off badly made item.

kustom chris

Still after looking up diff info today every one is saying here the standard diff setup as per the manual seems to work fine as it is.

T4miy4 Guy
27-01-2010, 11:39 AM
Andy
Ok now I see where your coming from and yes I forgot about that - sorry.


No need to apologize Welshy, were all here to help;)

Andy

mole2k
27-01-2010, 02:33 PM
I ran it with the extra balls and it felt about the same too me, seemed to last a little bit longer. I run with overdrive and the front diff which has 8 center holes and 8 outer holes (manual indicates to use the outers) works even better when loaded up with diff balls. Extremely smooth and didnt slip.

DCM
27-01-2010, 02:42 PM
it alters the loading on the balls, the inner balls will have a larger loading than the outer balls, so you end up setting the diff according to the inner balls (slightly tighter), the use of the outer holes make for a smoother diff action.

kustom chris
28-01-2010, 01:42 AM
Thanks guys I suppose tamiya have spent thousands of man hours to know what's right cheers chris