PDA

View Full Version : Lipo trouble


moth898
05-02-2010, 03:36 PM
I tried installing my Team checkpoint lipo pack in my cat and found that the belt touches the center belt and pulley. What pack fits please?

mikeyscott
05-02-2010, 03:47 PM
What chassis do you have and what are the dimenstions of the LIPO?

moth898
05-02-2010, 07:52 PM
I have the cat sx lipo kit #079, the battery is a team checkpoint 5000 mah. Do orion or reedy fit better?

moth898
08-02-2010, 11:56 PM
I tried three lipo's, only one fit!!!! It was the flight power dark series. Can someone tell me what else fits

Dazzler
09-02-2010, 07:47 AM
I'm using the Robitronic 5000, 40c's. They fit fine.

bert digler
09-02-2010, 07:52 AM
I have the cat sx lipo kit #079, the battery is a team checkpoint 5000 mah. Do orion or reedy fit better?

does it have locating lugs on it

Swiss
09-02-2010, 07:56 AM
I use the Nosram 5300 40C Cells, must admit when first put in the cells needed pushing down to ensure the locating lugs were correctly aligned with the holes in the chassis... But they 'bed in' after a while...

Make sure the LiPo is correctly seated.

B&H Racing
09-02-2010, 12:21 PM
I run an LRP lipo upside down so the lugs are at the top.

Works with no problem

moth898
09-02-2010, 01:23 PM
Thanks for all the info, I have to say I'm a little discouraged with this lipo thing, getting the wire around to the esc wasn't a small task either. I have a degree in electo-technology (basically wireing and ic boards tech) and still had some trouble passing the wires through the belts without touching them. I hope Shumacher addressed these issues with the SX2.

Does anyone have the part number for the battery stays that hold the lipo from moving left to right.

mikeyscott
09-02-2010, 01:59 PM
Thanks for all the info, I have to say I'm a little discouraged with this lipo thing, getting the wire around to the esc wasn't a small task either. I have a degree in electo-technology (basically wireing and ic boards tech) and still had some trouble passing the wires through the belts without touching them. I hope Shumacher addressed these issues with the SX2.

Does anyone have the part number for the battery stays that hold the lipo from moving left to right.

I think what you are after is from Nortech - pm northy on oople about them.

If you have a LIPO with lugs on them, look at doing a chassis change? S1 or new SX2 chassis