still struggling on carpet !!!!

[mitch 66]

ive tried two setups for carpet and still stuggling :( its seems to roll to much in the corners!

if pushed just turns over? ive tried moving the shocks right out which helps but i still can not take corners as fast as in my b4 ? any ideas?

[Chris Griffiths]

Sent you that set up mate!


Chris

[matdodd]

What club are you running it at? Is it all carpet?

[jk007]

hi mate sound like your trying to hard to me, how long have u been rc racing for at club level:thumbsup:YORCC rules.

[super__dan]

How many rows are you cutting off the front tyres?

[RS Concept]

Hi,

I have fought with same "problem" on our let say tight carpet indoor track. Most of B4s can easily took over my X6sq in the tight corners.
I run the TRF shocks with original pistons- 1,3 front 1,4 rear- actually with siber asso springs around. Servo front position + 140g ballast behind the servo- lead.
What i have noticed is that the stagger tyres do not give enough grip so the way is to use the yellow minipins and start to set up the geometry of the car to this tyres.

Oil front 30wt rear 40wt....this should give more push on the rear to keep the front on the carpet.

Anyway, as Ellis mentioned.... ballast, thats really the one keypoint of the front grip of X6sq.

hope it helps lillbit.

regards,

Peter

[matdodd]

How many rows are you cutting off the front tyres?

If hes normal Dan none ;)

[mitch 66]

What club are you running it at? Is it all carpet?
DMS and its all carpet tight with a sweeper and jumps

[mitch 66]

hi mate sound like your trying to hard to me, how long have u been rc racing for at club level:thumbsup:YORCC rules.
7 years then 3 and just started again

[mitch 66]

How many rows are you cutting off the front tyres?
i tried 1 row off inner and outer ! and had bad understeer now not cutting them

[matdodd]

Give this setup a try
If its very high grip it might be worth trying the rear roll bar to