servo buzzing on HRS receiver

[fidspeed]

hi guys
sorry if going over old ground ,recently upgraded receiver to a futaba HRS to match my 3PK transmitter . I noticed my KO digital FET servo "buzzes" a lot more than it did before on my recently removed KO 301 receiver .
Is this normal in HRS mode ?

thanks in anticipation

DAVE

[Battle_axe]

hi guys
sorry if going over old ground ,recently upgraded receiver to a futaba HRS to match my 3PK transmitter . I noticed my KO digital FET servo "buzzes" a lot more than it did before on my recently removed KO 301 receiver .
Is this normal in HRS mode ?

thanks in anticipation

DAVE
this is normal all digital servos do it and metal gears seem to make the buzzing worse dont worry all should be fine

[sosidge]

Personally I would drop the radio down to standard response, this increased buzzing could be a sign that the servo is being overworked... I have seen a servo get roasting hot and fail after being used in HRS by mistake.

[fidspeed]

thanks for the heads up guys

will a futaba HRS receiver work in normal mode ??

Dave

[leeleefocus]

I expect the servo that roasted was not digital. I cooked a servo like this also that was not digital.

I've been running digital now for maybe 8 months in HRS mode and the digital servo's i now run are as good as the day i put them in. If your servo is digital you should be fine to run in HRS mode.

[super__dan]

You can run PDS KO servos in HRS more or PPM, but PS servos ONLY in PPM unless you want to cook it. I run both and to be honest can't notice the difference in running in HRS or PPM modes.