brushless problem

[b4-man]

Hia
just recently i have made the jump to brushless as i blew my brushed speedo up and it got replaced by an lrp ai non pro version but i have installed this into my car with an lrp erasor 15.5 and ae xp servo and this is where my problems began i placed it down and it begun to start and stop when i am on the power i have tried a few things ( crystals, sensor wire, reciever ) but i just cannot think why it happens would anybody be able to shine any light on the subject as i am completly stumped. :confused::confused::confused:

[emtee]

What sort of temperatures are you getting? Is the speedo/motor "thermalling" i.e. getting hot 'n tripping out? Have you changed your FDR to suit the BL motor? Does it happen straight away or after you have been running a bit? What is the voltage required by the speedo?

Drop a bit more info into your thread if you will please... I can't imagine any motor/speedo conflicts 'cos they are the same manufacturer...

[b4-man]

it does it the second it is turned on after letting it set up

[gazbaz2]

it does it the second it is turned on after letting it set up

Hi, does it stop as soon as you put the power on ?

[b4-man]

Hia it does but it like goes slow for 1/2 secs then fast and circles round like that and does not stop

[b4-man]

would soldering the little resistor things in help or even trying a different motor

[gazbaz2]

would soldering the little resistor things in help or even trying a different motor

just try a different motor matey if ya can