PDA

View Full Version : My mint B3


Chillout47
09-04-2010, 12:35 PM
Anybody still run one of these?

Welshy40
11-04-2010, 03:32 PM
Nope not that I know of, but I will be running a B2 at the next Petit if its happening next year. This car is a better car than the B4 so I would hold onto it if I were you. Better quality product.

Ema
11-04-2010, 10:06 PM
Like Welshy I still race my B2 buggy with decent results :thumbsup:.

These cars despite the 1995 design are already lipo ready and can handle easily the power of a modern brushless motor (7.5 on mine ;)).

Bye
Ema

corkyjohnson75
15-04-2010, 08:56 PM
Like Welshy I still race my B2 buggy with decent results :thumbsup:.

These cars despite the 1995 design are already lipo ready and can handle easily the power of a modern brushless motor (7.5 on mine ;)).

Bye
Ema
This is my rc10 ive not ran it yet its got a brushless 7.5 not to sure on the gearing for the brushless set up thou .

peetbee
15-04-2010, 11:19 PM
Looks nice!
Not quite a B3, but I am still running a T3, have enough spares to keep it running for ages hopefully!

Rocking Donkey
16-04-2010, 07:05 PM
I was racing my B2 until last year, but I'm now down to my last pair of wishbones. I don't dare race it again until I find a decent spares supply. Does anyone know where I can find any? I think I got DMS's last pair.

Also do the B3 wishbones fit, and are they significantly different?

Ben

Ema
16-04-2010, 09:41 PM
I was racing my B2 until last year, but I'm now down to my last pair of wishbones. I don't dare race it again until I find a decent spares supply. Does anyone know where I can find any? I think I got DMS's last pair.

Also do the B3 wishbones fit, and are they significantly different?

Ben

At the front you can use the B3 wishbones without any modifications, but always use two arms of the same kind.

At the rear if you want to use the B3 arms you also have to change the rear hub carrier because the arm is a little longer and the hub has a different offset that compensate the additional length.

Probably also the Tunder Tiger Phoenix BX ones will do the job as this car actually is a B3 :thumbsup:.

My suggestion is also to use the RPM front bumper, because with the original is quite easy to loose the front e-clips and when you hinge slide a litte out it is really easy to break the front arms.

Bye
Ema

Chillout47
16-04-2010, 11:59 PM
Its easy to get spares from eBay USA, you just have to look to see if they ship worldwide.

nicefrog
23-04-2010, 09:19 AM
I have a pretty mint B2 Team car with some B3 parts, still a very fast car. The build quality of the thing is very impressive, I guess they were still made in the states during this time?. I only drive it once in a while due to the parts not being all that easy to get. I plan to change it back to 100% B2 soon