View Full Version : Tech Support - Superb
mikeyscott
27-04-2010, 04:05 PM
Just spoken to tech support re an issue with a diff - Superb and I was shocked at the response.
This is why I'm sticking with this brand!
stegger
27-04-2010, 04:29 PM
What was the issue with the diff mike ?
stefke
27-04-2010, 06:09 PM
I'm very curious because I had my own diff troubles in the past. They're solved now following a small modification.
mikeyscott
03-05-2010, 05:39 PM
Whatever I did the new diff I recieved wouldn't stay done up. They've since replaced.
I put my old diff back in after a full rebuild and no probs.
bumrar
03-05-2010, 06:49 PM
I'm very curious because I had my own diff troubles in the past. They're solved now following a small modification.
Can I ask what this modification was? Im having problems with the diff in my cougar SV unwinding!
Ste
stefke
04-05-2010, 08:30 AM
First of all, you have to pay close attention to the installation of the C-clip, like mentioned in another thread here. Make sure the clip isn't overstretched after installation. It shouldn't move much in the groove.
This is the most important part.
Then I went further and did some "diff fixing overkill" after some of my diff screws broke off at the head.
This is a personal preference, but I never liked the original CAT diff screw system (with the 1,5mm hex counterscrew). So I drilled out the M3 thread in the hub, took a longer screw (with a stronger 2,5mm head) and simply used a classic M3 locknut to tighten the diff. Again, this is a personal preference but I prefer this method of thightening the diff over the original 1,5mm hex counterscrew.
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.