PDA

View Full Version : dex410 front hex


melanie
24-05-2010, 05:55 PM
Hi There

Can anybody help me I keep on striping the front rims where the hex fit in so I keep on throwing away rims please help:p

Hulk
24-05-2010, 06:07 PM
Make sure you use threadlock on your front wheel nuts and check them before each race to make sure they havnt worked loose.

Wheel tend to strip when the wheel nut has become slightly loose.

shanks
24-05-2010, 06:09 PM
Or go for Hot Boddies serrated nuts - they dont come un-done

Rebelrc
24-05-2010, 06:10 PM
I now use core rc serated nuts they seem to stop this.....only £1.99:thumbsup: and there slimmer so you can grind off the excess shafts so they fit in the box

telboy
24-05-2010, 07:08 PM
I use serated nuts and threadlock.

JohnM
24-05-2010, 07:47 PM
I now use core rc serated nuts they seem to stop this.....only £1.99:thumbsup: and there slimmer so you can grind off the excess shafts so they fit in the box

I use the same, haven't had any problems with them, until yesterday that is, fell off in two legs of the A final:(

annonymous
24-05-2010, 08:09 PM
i went to 12mm hexes . . . . now all i do is break drive shafts :blush:

AmiSMB
25-05-2010, 06:23 AM
I use HPI serrated nylock nuts to make sure they do not come undone.

wes
25-05-2010, 08:28 AM
been using serrated nuts with losi thread lock and had no problems

slowjun
09-12-2010, 05:54 AM
mine, tried using that thingy red thread lock that came with the Kit, no problem running but when its time to clean the tires... hahaha... that would be a problem... hahahah. crazy glue.... a bit hard to remove.....hahahah.