View Full Version : TRf 201 wing, should the holes line up ??
Colinevan
17-07-2010, 06:56 PM
Just a quick post.
Should the pre marked holes in the wing packs line up with the mounts. I ask as mine are way off and i will have to remark and ream or bend the plastic mounts out.
Iv had a look at other cars on here, but i can't tell at this stage.
Thanks
Col.
Jan Larsen
17-07-2010, 07:38 PM
Does it really matter? Just line the wing up, mark the holes with a sharpie and ream them out. Dont make them too big.
tony6187
17-07-2010, 07:54 PM
saw a thread on this somewhere else.they should be lined up if they dont then they are in the wrong way round(left on the right,right on left).apparently the are sided.cant confirm this though as mine are getting painted and havent mounted them yet
Colinevan
18-07-2010, 06:29 AM
Does it really matter? Just line the wing up, mark the holes with a sharpie and ream them out. Dont make them too big.
It doesnt really matter no, however Tamiya cars , esp trf ones are usually bang on with no dremelling, no binding and everything lies where it should, even the wing holes.
I had installed them the wrong way around and this cures it. To be honest i was very surprised that they are handed.
Col.
Colinevan
18-07-2010, 06:30 AM
saw a thread on this somewhere else.they should be lined up if they dont then they are in the wrong way round(left on the right,right on left).apparently the are sided.cant confirm this though as mine are getting painted and havent mounted them yet
Bang on, many thanks.:thumbsup:
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.