MHeadling
02-08-2010, 02:15 PM
I have put some Rayspeed 0.5 degree rear hubs on my X6 as I had them in the box from my B4, just a couple of Q's:
Shall I still run the 4 deg rear toe in block when using these or go the 3 deg one?
What hole shall I run the camber link in inner or outer??
How many spacers in mm shall I run under the ball stud on the hub end??
Shall I still run the 4 deg rear toe in block when using these or go the 3 deg one?
What hole shall I run the camber link in inner or outer??
How many spacers in mm shall I run under the ball stud on the hub end??