View Full Version : DB01-R and LiPo's
Jamesk
18-10-2010, 12:48 PM
I was just wanted to know what if any mod's where made to the battery tray to fit stick lipo's. I was thinking of smoothing out the raised cell flashes in the tray. Any veiws, mod's used would be good.
Jk
peetbee
18-10-2010, 02:09 PM
I ran 23mm tall lipos with no modifications at all. I did subsequently switch to the TA05 carbon battery strap - partly because it's slightly thinner but mainly cos it looked cool!
DaveG28
18-10-2010, 02:42 PM
Yep, for tall lipo's the ta05 carbon strap and spacers under the clip mounts do the trick, no other changes needed, even for big lipo's!
Crazy L
18-10-2010, 06:37 PM
I got a bit ocd with mine, dremeled out some of the cell webbing, just to lower the lipo a bit, so it sat a little and I was able to screw in the battery strap retainer posts a turn or two.:thumbsup:
Jamesk
18-10-2010, 07:08 PM
Thanks chaps, ill do the spacer thing for now.
marco NL
19-10-2010, 09:13 AM
http://www.modrc.com/cars/db01r/
just dremel the webbing on the chassis so the tray is flat, the webbing stuff isnt even flat so the battery wont sit true every time u put it in, it means the battery sits better in the chassis as well as lower
kaszal
27-10-2010, 03:12 PM
I didn't dremel the webbing but put some thick foam tape in the recesses on the bottom to cushion and grip the Lipo. The carbon strap is nice too.
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.