PDA

View Full Version : Nathan Waters - Ardent Setup shock oil help?


008-Racer
06-11-2010, 01:13 PM
Hi I hope you guys can help!

I have got myself a 410 (1st 4wd offroad car!) and I am trying to follow Nathans Ardent setup as to start with I will be indoors for a while!

He has shown the oils to be 400 CST in the front and 450CST in the rear

What brand of oils does he use? As I normally run Much More oils and if I was to follow a CST rating for these oils they would be mega thin!!

Thanks for your help guys

simoncrabb
06-11-2010, 07:01 PM
I use much-more oils and run something around 400 and 450. They don't seem 'mega thin' to me?

008-Racer
06-11-2010, 07:51 PM
The setup sheet reads in cst and if I continue to use Muchmore oils I would need to use 100 -150 to get to 400-450 cst so just a little confused

http://www.rcracinguk.com/images/cstchart.jpg

ned
06-11-2010, 10:11 PM
Hi,
The oil I use is the soon to be released Durango oil which is the same as Edit oil. How this compares to other oils measured in CST I am not quite sure but as a losi equivalent it would be around 35 front 37.5 rear. It was a bit of a strange setup though with the rear being particularly stiff due to a flat landing from a jump on the apex of a corner. Anywhere around 35 (400 CST) all round would normally be fine on carpet.
Nathan Waters

008-Racer
06-11-2010, 10:26 PM
Nathan your a gent thank you so much for clearing that up

simoncrabb
08-11-2010, 11:41 AM
The setup sheet reads in cst and if I continue to use Muchmore oils I would need to use 100 -150 to get to 400-450 cst so just a little confused

http://www.rcracinguk.com/images/cstchart.jpg

I honestly don't believe that chart, I'm sure Much More oils are just regular cst.

Maybe my setups have been way off!

Or, maybe I need to switch oil to Durango so I know I'm not wrong!