View Full Version : cougar front shock limiters
Hi,
Iv noticed on some of the setups it says 2mm front shock limiters,what do they do(dont state the obvious)and when would you need to use them,
thanks
Cockerill
06-01-2011, 08:38 PM
I normally use limiters when using Stagger ribs to ensure that the droop/uptravel are still correct, as it is a smaller diameter tire.
I try to ensure that the front always as slightly less droop & uptravel when compared to the rear.
i run the lower front shock as i run with stagger`s,i thought it was for when you used them,but it give more up travel than the rear and not much less on the downtravel,iv got mt rear ball cups undone 3 turns,
am i just better off putting the old shock tower back on?
deepdale11
06-01-2011, 10:10 PM
whats the part number for the 2mm front limiters??
The Doctor
06-01-2011, 10:16 PM
Mark, I'm getting worried about the number of technical set-up threads you're creating recently. Are you taking this seriously now or something? ;)
Cockerill
06-01-2011, 10:16 PM
i run the lower front shock as i run with stagger`s,i thought it was for when you used them,but it give more up travel than the rear and not much less on the downtravel,iv got mt rear ball cups undone 3 turns,
am i just better off putting the old shock tower back on?
I would leave the tower on, otherwise you won't have enough front droop. Then you can just limit uptravel.
whats the part number for the 2mm front limiters??
I use 2x 0.030" Associated shock limiters, but any 1/8" ID spacer should work.
ikey ji
06-01-2011, 10:32 PM
I would leave the tower on, otherwise you won't have enough front droop. Then you can just limit uptravel.
I use 2x 0.030" Associated shock limiters, but any 1/8" ID spacer should work.
Tom, you're the man! Thank you for being so available on forums...;)
deepdale11
06-01-2011, 10:44 PM
Tom, you're the man! Thank you for being so available on forums...;)
I second that, thanks Tom!!
Northy
06-01-2011, 10:58 PM
He's a good kid :lol:
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.