PDA

View Full Version : Corallys or deans?


westie
15-02-2011, 12:15 PM
Been using deans for ages debating on converting to corally connectors whitch ones do you guys go for?

Luke

Chequered Flag Racing
15-02-2011, 12:22 PM
I prefer the Corally 4mm male & female
but if you use these it's best to wire them up so you have one wire that is shorter than the other so they don't reach the wrong terminal

Swalls
15-02-2011, 12:24 PM
Corally's for me, used them for years now. I find you can make a much neater electrics setup using them. Just make sure you make one of the leads too short to reach the opposite batt terminal.

digitrc
15-02-2011, 12:35 PM
Depends on the packs you use.

Corallies for packs which have corally sockets. Deans for stick packs that have a connector on the end of a wire.

ch!3f
15-02-2011, 12:52 PM
i use both but prefer corally by miles deans can get damaged on the male pins where as corally only get damaged if you squash them.

Chequered Flag Racing
15-02-2011, 01:19 PM
used them for years now. I find you can make a much neater electrics setup using them.

Ditto

been using them since late 93 when I got sick of the larger PowerPole connectors, not sure if Deans were out in 93

blue_pinky
15-02-2011, 01:41 PM
Corallys have slightly higher current rating than Deans, but have the downside of being easy to connect the wrong way around if your not careful!

Big G
15-02-2011, 02:54 PM
I started off with the B44 on deans with saddles (obv)

Then I moved to the Cat SX which was a pain with the extra wire so when I swapped to sticks I got corrally's and routed my wiring so it didn't go through the belt.

Then back on the durango I decided to go corally as this would make a tidier install

OneKiwi
15-02-2011, 03:57 PM
where do you get them from?

westie
15-02-2011, 09:29 PM
Think i may switch to corallys then ;) give me something to do on saturday before ardent :D