PDA

View Full Version : Tresrey rear hub fitting problem


dasbo
16-02-2011, 09:51 PM
Hi folks,

I am just trying to fit my new Tresrey rear hubs to my DEX but I've hit a snag. It seems the shape of them does not allow me to use the knuckle spacers that sit between the hub and the wishbone. (TD part no 709006)I've had a look to see if Tresrey sell smaller spacers to fit, but they only have caster spacers which are a larger diameter and would only make the problem worse.

So how is everyone else getting theirs to fit? Are there other spacers which work?

Thanks in advance:thumbsup:

PS. I've tried the dremel but have stopped before I make the hub look awful.

mikeyscott
16-02-2011, 11:44 PM
Tresey site has a link showing what parts need to be modified

konich
17-02-2011, 04:27 AM
Take the 3mm spacer out and run the 2mm spacer. Also trim the rear arm brace so the hub doesn't bind in full suspension travel. My 1 degree hubs work great with this setup.:thumbsup:

jatetu
17-02-2011, 09:24 AM
With the dex410R, direct fit, no mods required with the 1º alu rear hub

mikeyscott
17-02-2011, 09:28 AM
With the dex410R, direct fit, no mods required with the 1º alu rear hub

Assume that's because of the plastic washers etc.

stegger
17-02-2011, 01:39 PM
Tresey site has a link showing what parts need to be modified

Where fella ?

Piman
17-02-2011, 04:14 PM
It is not a great illustration:

http://tresreyblog.com/?eid=218

James

dasbo
18-02-2011, 05:50 PM
Cheers James.

Hubs now fitted. Job done!

stegger
18-02-2011, 09:05 PM
It is not a great illustration:

http://tresreyblog.com/?eid=218

James

Cheers dude :thumbsup: