PDA

View Full Version : crunch spacers on the driveshafts?


captainlip
21-03-2011, 07:41 PM
the manual says put them on the outside of the hubs on the wheel side, which i have been doing, but what - or + effect will i get putting them on the inside thus shortening the wheelbase?

captainlip
21-03-2011, 08:16 PM
sorry i mean the distance bushing. any help while i have the shafts out.

ian h
21-03-2011, 08:39 PM
I would imagine that by moving them inside the hub you would move the drive shaft too far into the diff outdrive. Not good I would imagine.

captainlip
21-03-2011, 10:15 PM
good thinking! put them back as they should anyway.

Hulk
21-03-2011, 10:20 PM
Hi mate,

by putting the gold washer on the inside of the hub your reducing the cars track width.

A narrower rear track width will:


increase grip at corner exit
increase high speed understeer
be more prone to grip roll
A wider rear track width will


increase rear grip at corner entry
increase high speed on throttle steering
use to avoid traction rolling
Hope this helps :thumbsup:

Craig

captainlip
21-03-2011, 10:24 PM
cheers boss! will leave it as the latter