PDA

View Full Version : XXX-CR Barking diff??

Suggitt
06-12-2007, 01:04 AM
Ive had a quick look in this section but couldnt find anything, so sorry if its been discussed before.

My diff was barking so i decided the rebuild it as i was told the only thing that causes this is the diff, i replaced everything except the top slipper shaft, and it was ok for half of a pack of cells, untill it started again?

Would be greatful if anyone has any idea's.

Kev
super__dan
06-12-2007, 07:53 AM
Sounds like it's loose!
ashleyb4
06-12-2007, 08:48 AM
It could be either way according to the manual they say it cna bark when it tight or loose but ive never heard a diff bark when its tight so yea itsproberly loose.

A
Wraggy
06-12-2007, 08:59 AM
It could be either way according to the manual they say it cna bark when it tight or loose but ive never heard a diff bark when its tight so yea itsproberly loose.

A
I will go with Dan on this ,sounds loose to me, ive heard B4's do it also ..
Southwell
06-12-2007, 09:01 AM
LOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOSE
Northy
06-12-2007, 09:01 AM
Too loose. Every diff will do it if too loose.

Once you build a new diff, and run it a bit, you need to readjust it as it will have 'bedded' in.

G
Wraggy
06-12-2007, 09:24 AM
LOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOSE

your Keys stuck again Ian :p:p;)
Southwell
06-12-2007, 09:56 AM
your Keys stuck again Ian :p:p;)

Ooooooppppssssss :D
Suggitt
06-12-2007, 12:08 PM
ok, shall take out and tighten accord to manual again, see what happens.

Thanks
KevLee
06-12-2007, 12:36 PM
You don't need to take it out to make adjustments. The screw head should be on the motor side. All you need to do is stick an allen key or something down the slot of the head to lock the screw to the diff outdrive. Then just turn the opposite wheel clockwise to tighten it.

Does that make sense?:wtf: it's really easy to make quick adjustments.
Wraggy
06-12-2007, 12:45 PM
You don't need to take it out to make adjustments. The screw head should be on the motor side. All you need to do is stick an allen key or something down the slot of the head to lock the screw to the diff outdrive. Then just turn the opposite wheel clockwise to tighten it.

Does that make sense?:wtf: it's really easy to make quick adjustments.

yes it does kev unless he has the diff in the wrong way ??? :eh?: then in which case its not on the motor side ..
KevLee
06-12-2007, 12:57 PM
yes it does kev unless he has the diff in the wrong way ??? :eh?: then in which case its not on the motor side ..

Good point!
ben
06-12-2007, 05:14 PM
ive just rebuilt my B4 diff and it was far too loose and it was "barking like a dog" so i tightened it up and it was good to go.

lil ben