PDA

View Full Version : X2C Bumper

duarte7
07-04-2011, 11:45 PM
Hi, I was wondering if the B4 bumpers from RPM fit in the Ansmann X2C I donīt like the original bumper is to small. Regards.
bigred5765
08-04-2011, 12:03 AM
lol your not supposed to use em
duarte7
08-04-2011, 07:02 AM
True, but in my kit the bumper was missing. So as I need to buy it I would prefer the bumper from B4, that's why I asked.
ben44
08-04-2011, 07:45 AM
The best is to take the big bore. On the front 1 hole of 2 you putt at 1.2 Mm on the rear all the hole at 1.2Mm
Dreadstar
08-04-2011, 10:27 AM
They will fit,but you need to modify them slightly. Remove the location dimples on the back of the bumper,and slightly elongate the mounting holes,but it will fit.
duarte7
08-04-2011, 01:02 PM
By elongate are you saying that I need to make them larger?
damselfly
08-04-2011, 01:25 PM
By elongate are you saying that I need to make them larger?

Yes. I'd also recommend countersinking the holes once this is done too.
This is the result;
duarte7
08-04-2011, 03:24 PM
Thanks for the help I will install the one that is similar to the original but its a bit longer.