dropped a clanger

[reg]

Hi,iv bought the HRC block and iv put all the shims and inserts in the same box as the LRC ones:confused:...........there are some with 22t on them all,then some without,but there are 2 with 2deg but not 22t on,but one is thinker than the other
please help a numpty head:woot:

[DCM]

LRC shim will be thinner than the same HRC block, simples!

[reg]

fffffffaaankkkkkkkkkssssssss:woot:

[steveproracing]

Lrc shims thinner. But lrc inserts thicker!!

[Wacker 2]

Lrc shims thinner. But lrc inserts thicker!!

You mean HRC are thicker!! :woot:

[steveproracing]

No. Inserts are different to shims !!
The shims are the flat pieces of plastic
The inserts are the plastic parts that fit in the front pivot block


In the LRC kit
The shims are thinner
The inserts are thicker

In the HRC kit

The shims are thicker
The inserts are thinner

This is because the shim and the insert work together so that the pivot block can move up or down whilst maintaining gearbox at a standard height!!

Hth

[Chalkie]

The LRC shims and inserts are marked with a T after the numbers whilst the HRC set isn't.

[reg]

thanks chaps:thumbsup:

[DJ's Dad]

Reg, I only realised yesterday that the shims have got notches out of them corresponding to which number they are. For example the 2 degree one has two full depth slots in, the 2.5 degree one has the two full depth plus a third half depth one in the centre, etc. Mine don't have any numbers on that I could see.