Hard case lipo into 22 and screw help

[Juttie]

As title im building my 22 and have just tried my lipo and its too tight a fit and wont slide all the way back any ideas alsois it just me or are the hex head screws really soft rounded off a few:thumbdown:

[stegger]

Are you using saddles ? Screw heads are fine, just make sure the tip on your driver is good ;)

[Juttie]

its a hard case stick

[ian h]

its a hard case stick

Not gonna fit, needs saddles or a stubby losi lipo.

[Juttie]

oh i thought you only needed stubby if running mid motor this is getting expensive lol new batt needed then.

[JohnM]

A stick pack should fit just fine in a rear motored car, which one are you using? is it super large?

[Juttie]

turnigy 5200 hard case

[reg]

there is a tread in here about the 22 with stick full stick pack fitted to the mid i think

[Razer]

turnigy 5200 hard case

So the batteries are to tall? If it has the bumps for fitting in Ni-MH chassis, you could just dremel those down. Also removing the foam strips from the chassis can make a bit more room.

[ianhaye]

the turnigy 5200 are massive!! way to tall.

[Juttie]

I now know that :) if i took it out of the hard case cand you get like some heat shrink to cover the batt back up?????

[wrightcs77]

I ran those batteries by taking off the top half of the battery case. Sounds funny, but works great.

[mattybucks]

I ran those batteries by taking off the top half of the battery case. Sounds funny, but works great.

WTF!

I don't think my local clubs will allow that!

[Juttie]

can anyone then recommend a lipo that does not cost the earth

[jcb]

I'd have a peak on the brca homologation list on, at least that way you know they are legal for BRCA meetings and have passed the relevant safety tests.

http://www.brca.org/sites/default/files/library_files/BRCAchairman/2011%20BRCA%202S%20Stick%20LiPo%20List%20v1%20pdf1 _1.pdf


The obvious answer to batteries would have to be the xcelerin range, but I have no idea how much they cost.

[/tobys]

Intellect's from ebay are pretty good value. The Losi, Vampire and Orions are all decent value for UK-sourced Lipos. HTH :thumbsup:

[spindles69]

Have put a stick lipo in my son's 22 in mid set up.
With lrp sphere and original shell.
Made an ally plate with 4 mounting posts.the two at the front are a bit longer just so the lipo clears the low profile servo.
So please people no more moaning about no room for electrics,it can be done with a little bit of thought.
24155

24156

24157