1258 in b44?

[Jnunu1]

Hi. Thinking about getting a savox 1258 servo for my b44 but someobe said they thought the casing would need to be filed down to fit?

Does anyone have any advice on this? Would a 1251 low profile be better?

Thanks

[ian h]

Hi. Thinking about getting a savox 1258 servo for my b44 but someobe said they thought the casing would need to be filed down to fit?

Does anyone have any advice on this? Would a 1251 low profile be better?

Thanks

I used to run one in my B44. Fits straight in.

[Jnunu1]

Cheers for that.

[RoyalCBR]

I have the standard Savox servo and everything fits fine.

[Jnunu1]

Thanks guys - 1258 on the way!

[gazhillAE]

In the b44.1 it will need the edge dremelled down yes!
:thumbsup:

[GRIFF55]

strange, it didnt in mine?

[blue_pinky]

Not sure...was going to say I didn't do anything to mine either...but then I have a vague memory that I maybe just trimmed a tiny bit of the corner off the top corner of the mounting flange to give a touch more clearance next to the drive shaft?

Got one in mine quite happily though...only very minor 'tweak' if anything is needed :thumbsup: