installing rudebits weight

[losichris]

best method?
Dont fancy drilling, would double sided/or velcro be strong enough?

[mattybucks]

best method?
Dont fancy drilling, would double sided/or velcro be strong enough?

What weights, where to on the car, and which car. I'm sure Tony thought about it before making the weights.

Have you tried to contact him?

Personally I woundn't use velcro. So some decent servo tape maybe the way forward.

[AndrewCaunt]

best method?
Dont fancy drilling, would double sided/or velcro be strong enough?

Best way is to Place in Chassis and drill through with small drill bit.Then open out with clerance drill.Counter sink from under chassis.Hope this helps.

[mattybucks]

Best way is to Place in Chassis and drill through with small drill bit.Then open out with clerance drill.Counter sink from under chassis.Hope this helps.

Really?? Will that not change the weight? If there was supposed to be a hole in it i'm sure Tony would have sold it like it.

PM Tony or wait for him to respond to the thread before getting your drill out.

[Pops]

Really?? Will that not change the weight? If there was supposed to be a hole in it i'm sure Tony would have sold it like it.

PM Tony or wait for him to respond to the thread before getting your drill out.

I think andrew means spot drill the chassis through the existing holes in corner weights etc to mouny in chassis

[mattybucks]

I think andrew means spot drill the chassis through the existing holes in corner weights etc to mouny in chassis

my bad:confused:

[losichris]

sorry, its for the x6.
and its for the whole drill set, servo, speedo,lipo and rear weights

[NeilRalph77]

Best way is to Place in Chassis and drill through with small drill bit.Then open out with clerance drill.Counter sink from under chassis.Hope this helps.

Agreed but the chassis are awful to countersink you'll go steady and think you've got them nice and concentric then on inspection find the darn things wandered, the lipo weight's just sit in loose