PDA

View Full Version : DEX210 internal gear ratio


BostonNelson
20-08-2011, 07:57 PM
The spur gear is 87t (48dp) if I'm not wrong. But what about the int gear ratio for both mid and rear config.

Andrew Twigger
20-08-2011, 08:21 PM
Durango told me the ratio is 2.6:1. 3/4 gear config. was not specified so on that basis one would presume it is the same for both? Happy to be corrected though.

mikeyscott
20-08-2011, 08:37 PM
RW racing also do spurs in other sizes

Stu
21-08-2011, 08:49 AM
Durango told me the ratio is 2.6:1. 3/4 gear config. was not specified so on that basis one would presume it is the same for both? Happy to be corrected though.

It can only be the same, number/size of idlers does not affect the ratio.

mark christopher
21-08-2011, 08:55 AM
It can only be the same, number/size of idlers does not affect the ratio.

unless the idler gears are different sizes

Big G
21-08-2011, 10:29 AM
still doesn't make any difference even if they are different sizes.

at the end of the day (god I hate that saying) it's the layshaft cog size against the diff cog size. what's in the middle doesn't matter.

dpackster1980
21-08-2011, 01:52 PM
still doesn't make any difference even if they are different sizes.

at the end of the day (god I hate that saying) it's the layshaft cog size against the diff cog size. what's in the middle doesn't matter.

I think you find it does, only if there's a belt between them it doesn't. :p

discostu
21-08-2011, 02:28 PM
why would a belt make any differnce the calculation is layshaft divided by diff=internal ratio.

Stu
21-08-2011, 07:13 PM
unless the idler gears are different sizes

Idlers make no difference to ratio, no matter of size. Only gears driven by or driving a shaft affect the ratio.

mark christopher
21-08-2011, 08:02 PM
Wrong thread

dpackster1980
22-08-2011, 08:23 PM
Idlers make no difference to ratio, no matter of size. Only gears driven by or driving a shaft affect the ratio.

Doh, just found a web page and I stand corrected. :bored: