minimum stopping distance

[Micha_MX4]

hmmm, I'm not sure if the break is working okay with my speedo
Keyence Infinity A-01B.

Stopping distance Yok BX from wot 17/84 10turn Reedy Krypton is at least
8 meters on the street.

Schottky diod on the motor and the standard that comes pre soldered.

Tx setup should be okay...

What do you think?

[sparrow.2]

That does seem very long...

Things to check could be ( in the order I'd look):

1. Brake settings on the speed control? (Reglereinstellungen)
2. speed control set properly to the transmitter?
3. Transmitter brake travel limited?
4. Diffs on the car tight?
5. are you running a one-way (Freilauf) on the car and are the tires slipping at the back?
6. Tires on the rims? :lol:

More questions PM me and I'll give you the full rundown in German...

[xx4-nutter]

comm health, brush springs and brushes ?

[RogerM]

My car doesn't stop in much less with Nosram / LRP speedos and Novak brushless motors.

[Micha_MX4]

the Reedy Krypton was new, tested 3 packs...

I swapped speedos and breaking was there... (I could lock the rear tires on
wet street)

my problem was that while wiring the car I switched the minus batt connection with minus motor (soldered motor to esc).
I NEVER made such an error before :confused: Result: looks like i put
motor and esc in parallel (running in the Reedy with 7.2 Volts full throttle -
oh my...)

Of course I didn't see my fault and "tested" a couple of times, thinking
the (brandnew in box) speedo had an error.