Sumilidon
29-08-2011, 02:58 PM
Hello all,
Well I'm getting the 8.5T motor set up (ESC has a faulty fan but I am expecting them to replace that) however I am having issues with my CODE transmitter.
The steering does not seem to be recognised, and the throttle would appear to be always on.
I plugged an old 27mhz setup into it which is how I know it defaults at 100% forward, and the steering works fine.
The steering on this transmitter worked fine last week on my old brushed system - only thing I touched was the trim.
It is a CODE DSSS (using Code CR139 receiver)
Oh and I have also tried resetting the tx and re binding the rx. It worked properly for a brief moment, then went back to fail
Well I'm getting the 8.5T motor set up (ESC has a faulty fan but I am expecting them to replace that) however I am having issues with my CODE transmitter.
The steering does not seem to be recognised, and the throttle would appear to be always on.
I plugged an old 27mhz setup into it which is how I know it defaults at 100% forward, and the steering works fine.
The steering on this transmitter worked fine last week on my old brushed system - only thing I touched was the trim.
It is a CODE DSSS (using Code CR139 receiver)
Oh and I have also tried resetting the tx and re binding the rx. It worked properly for a brief moment, then went back to fail