PDA

View Full Version : Can you remove and reuse molded pinions


jon kedge
30-09-2011, 08:55 PM
As the title ask's,is it possible as i,m upgrading the motor from a 280 to a 370 in my losi mini high roller,don't know what pitch the pinion is but looks similar to a mini t one. thanks jon kedge

sldmodels
30-09-2011, 10:39 PM
Don't know exactly on that onem but you can with Scalextric ones, so would expect the same, but you're better off with an alloy pinion if poss.

peetbee
30-09-2011, 11:12 PM
You can with the mini t ones, but the more that you reuse them the more likely they are to slip.
I believe they are 2.3mm shaft on the losi motors and a lot of the aftermarket motors seem to be 2mm shaft so if it slips straight off then that could be the cause

jon kedge
01-10-2011, 09:08 AM
Thanks for the replies,i will measure the 370 shaft diameter and look for an alloy pinion but don't know where to get them from as it's all 1/10 pinions i have.Which shops do this micro stuff and what dp are the spurs on the losi,s ,

peetbee
01-10-2011, 10:48 AM
Well the mini t is 48dp
For 2mm shaft pinions I know www.tracksidespares.co.uk keeps the RC18 ones in stock

sldmodels
01-10-2011, 05:19 PM
I'm so stupid, RW Racing should have them, and if they don't, they can probably make them for you.

jon kedge
03-10-2011, 10:14 AM
Thanks for the link to trackside spares,some ordered today, jon kedge