View Full Version : TRF201 Front Trailing Axle
DaveG28
04-10-2011, 04:59 AM
Never realised until reading rctech tonight that the 201 has offset front axles, so you can adjust how much trailing axle it has....
So, what does this adjustment do in terms of setup?
Lee Martin
07-10-2011, 08:22 AM
Why dont you know this??? O yeh...i have seen your cars ;)
its a simple one really.
think about it ;)
DaveG28
07-10-2011, 07:49 PM
Well I had been running different settings each side, just never noticed, I'm not alone though!!!
I know it changes wheelbase (and weight dist) but moving it out of kind with the upright angle impacts it to, just not sure how!?
guinness
07-10-2011, 11:01 PM
dumb question,witch parts are u talking about?
I never noticed and now I've checked mine are set different :blush:. Shame they dont bring out some with a more agressive setting.
guinness
14-10-2011, 11:06 PM
so when a setup sheet says +1 does mean that is on the front position?
what difference makes front or back?
thanx
LhOrLoGeR
15-10-2011, 08:02 AM
Use front with 30° caster bloc and rear with 25° caster bloc, not to change the wheelbase...
wildwillydriver
17-10-2011, 10:37 AM
so when a setup sheet says +1 does mean that is on the front position?
what difference makes front or back?
thanx
Here how it works, if i understood correctly....
The front axles (BB33 - Page 10 on manual) are offset. You can position them either forward or back (F&R on Set up sheet). This can be done turning BB33 180° to give more or less trailing.
The +1 or 0 on the set up sheet, refers to the shim (C1 - Page 10 on manual) +1 if you use it or 0 if you leave it out.
That said if you use the manual set up you have F and +1.
Hope this help.
Bye
WWD
:)
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.