X-6 rear turnbuckle length

[Dunc]

When using the E-Speed camber mod., do you have to run a shorter turnbuckle than the 2" one supplied in the B4 FT kit?

Thanks!

[millzy]

no FT ones will be fine, they lower the camber link a few mm and designed to used the origional turnbuckles

if your in dought check out there forum or email chazz.

[Chrislong]

I use a shorter turnbuckle - not sure on length, think its 40mm - I will check tonight

[Dunc]

Thanks guys.

Chris, if you could let me know the length of turnbuckle you use that would be great.

I asked because on my B4 the ball ends use virtually the entire thread at the rear already, so going any shorter would be difficult (I've been assuming the X-6 geometry is similar without the E-Speed camber mod.).

[super__dan]

I Think I use the std one but I always run the outer or middle hole on hub therefore the link is only the same length as say short on hub and short on tower.

Before I used to run the inside hole on hub a lot but since using the E Speed hangers it's middle or outer hub holes all the time.

[paulo]

I was wondering what length turnbuckle I would need and also where to get them from as I found that with the standard turnbuckles I could not get the link short enough and then had to cut them which only left a few threads which after 4 rounds they finaly gave up in the final.

I am using the rayspeed 0 degree hubs and the furthest hole with the E Speed camber mod if this helps.
Many thanks in advance