PDA

View Full Version : DEX 210 turnbuckle set up


kabilay
26-10-2011, 08:17 AM
Did you use the setup/ length of the turnbucles mentioned in the online manual? 12,5/ 19.5 and 20mm?

jkclifford
26-10-2011, 09:01 AM
Yes, found it a bt upright all round.

Bungleaio
26-10-2011, 09:08 AM
I didn't use the figures listed in the manual. I just wound the camber links in so they were about level and then adjusted them when on the car to my desired camber angle.

The toe links I adjusted so they were the same length then set them so I had about 1 degree toe in on the car using a toe gauge.

Big G
26-10-2011, 10:14 AM
I just fired mine together somewhere close and then fine tuned them to Adam's Worksop setup sheet.

Piman
26-10-2011, 10:51 AM
I have never found manual lengths (any brand) to be right for any setup. I think they are given as a starting point to adjust from once the car is built and before it is first used.

James