PDA

View Full Version : servo saver ( again :( )


losichris
23-11-2011, 10:01 PM
ok this evening , my £100 ko's life came to an end!!
before i run the car again after purchasing another servo, i definatly want a servo saver solution....
would be very grateful if anyone could share some ideas?
Cheers
Chris

reg
23-11-2011, 10:11 PM
dont the ko run a plastic gear at the bottom,is it just that which has gone,

bigred5765
23-11-2011, 10:14 PM
run a full metal gear set servo ie savox
how did you break it before you run it

losichris
23-11-2011, 10:33 PM
run a full metal gear set servo ie savox
how did you break it before you run it

Just pulled it apart now, seems the small plastic gear has gone.
Ran the car a few times, didnt do much to it on this occasion, odd landing and the car was still on 4 wheels then it went pop.

reg
23-11-2011, 11:10 PM
i will stand corrected bit ko stuff is more for on road,you can order the plastic part and is much cheaper than a new servo,but it will go again,as bigred5765 says your better off with what he said:thumbsup:

AmiSMB
24-11-2011, 08:10 AM
I tried using servo savers a few years ago but the biggest problem is that most of them are not strong enough as they end up trying to save the servo in sweeping corners and it makes the car feel really bad. I just run a Savox now and it is job done. I know that if you hit anything hard enough you will still break it :)

hopsing
26-11-2011, 04:56 AM
Savox servo here with no issues...also ran a Futaba metal gear servo with no problem. Definitely switch to metal gear and you wont have any servo problems :thumbsup: