View Full Version : Ride height guage
OneKiwi
28-11-2011, 05:50 PM
Whats a good one?
I have seen people with small alu square and hexagonal blocks that have different heights on different sizes.
Any tips besides the losi one??
GRIFF55
28-11-2011, 05:55 PM
LMR one:thumbsup:
dobber
28-11-2011, 06:01 PM
LMR one:thumbsup:
Linky linky?
OneKiwi
28-11-2011, 06:43 PM
I have seen that one at telstar-racing 14 quid isn't too bad
GRIFF55
28-11-2011, 06:49 PM
Should be on here:thumbsup:
http://l-m-racing.co.uk/?page_id=2
t8rtot
28-11-2011, 07:10 PM
make sure your on an ultra flat surface when using it (glass or setup board) otherwise you'll get different readings. TRUST ME
simoncrabb
28-11-2011, 07:15 PM
I use the handle of my wheel wrench which happens to be 19mm round...
Matt Butcher
28-11-2011, 09:09 PM
I use the handle of my wheel wrench which happens to be 19mm round...
meeeeeeee tooooooooo :thumbsup:
mark christopher
28-11-2011, 09:44 PM
Team associated one
David Poulter
28-11-2011, 09:56 PM
Should be on here:thumbsup:
http://l-m-racing.co.uk/?page_id=2
I agree with Griff the LMR one is the best :thumbsup:
mattybucks
28-11-2011, 10:04 PM
LMR!!
http://www.telstar-racing.co.uk/products/lmr-off-road-ride-height-gauge/
kayce
28-11-2011, 10:12 PM
Whats a good one?
I have seen people with small alu square and hexagonal blocks that have different heights on different sizes.
Any tips besides the losi one??
I've always just made my own out of scrap lexan, 100mm long, with the size marked with a sharpie on one end and a hole on the other to run a piece of chain through. That way if I want to make another, I can just add it to the collection. Cheap and easy enough to do.
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.