PDA

View Full Version : Akula Racing 210 Front Shock Mount Problem..?


micky blue83
28-11-2011, 09:12 PM
Hi All,

Just wondering if anyone has had any issues with the Akula Carbon Front Shock mount..? :confused:

The turnbuckle is rubbing on the mount as it travels up and down..? tryed to shim it out, but theres too much of an angle..?

I have probably done somethng wrong..?:confused::lol::bored:

Any ideas would be great..:thumbsup:

Thanks

Michael

AmiSMB
28-11-2011, 09:23 PM
Ball joints in the end of the shocks are the wrong way round. The ball part goes towards the rear of the wishbone.

sparrow.2
28-11-2011, 09:24 PM
Have you shimmed both ball-ends? The one on the tower and the one on the c-hub.

mark christopher
28-11-2011, 09:34 PM
Ball joints in the end of the shocks are the wrong way round. The ball part goes towards the rear of the wishbone.
shocks dont affect turn buckles rubbing on towers?

jeffrey
28-11-2011, 09:48 PM
trim a bit of the shocktower
thats how i have done it.
2min work with a dremel =)

hope this helps
http://img217.imageshack.us/img217/9741/img4144wd.jpg (http://imageshack.us/photo/my-images/217/img4144wd.jpg/)

Uploaded with ImageShack.us (http://imageshack.us)

micky blue83
28-11-2011, 09:51 PM
Hi Guys,

The Ballstud is the correct possition, and if i was to shim both side i would need to shim 3mm minimum.. probably more..:confused:

Has anyone got any pictures off these fitted..?

Thanks for the help.... :D

jeffrey
28-11-2011, 09:54 PM
check the post before yours :p

mattybucks
28-11-2011, 10:01 PM
You do need to shim both sides.

micky blue83
28-11-2011, 10:06 PM
Thanks Jeffery... :thumbsup:

Carbon dust is in the air...:)

Andrew Twigger
28-11-2011, 10:16 PM
shocks dont affect turn buckles rubbing on towers?

They do in this case because the balls that sit in the shock ends are offset to allow the shock to overcome the turnbuckle.

OneKiwi
29-11-2011, 06:31 AM
does having the balls/cups on the front change the geometry (obviously) that it requires different setup? Just wondering

gainsy
29-11-2011, 07:47 AM
If you shim more than 2mm on the castor you will need a slightly longer ball stud thread or they will undo during the race, had this problem a few times, in the end i used a super strong threadlock as i haven't got round to getting a longer ball stud
hth

mark christopher
30-11-2011, 10:47 AM
They do in this case because the balls that sit in the shock ends are offset to allow the shock to overcome the turnbuckle.

Well re read his post his turnbuckle is hitting the tower, not the shock. So as I said shocks are nothing to do with it......