View Full Version : Turnbuckle Rob Ends
knighthawk
30-11-2011, 08:18 PM
Stupid question and has prob been answered
My 511 rod ends keep coming off
which ones are recommended as a replacement
I see loads of 511/502's going round with white rod ends
What are they?
Thanks for any help
Dez
Donutt
30-11-2011, 10:28 PM
I've used these for a couple of years.
http://www.jespares.com/electric-models?page=shop.product_details&flypage=flypage.tpl&product_id=9766&category_id=1285
Replace all the front ones with these (one pack will do) and you'll never pop another balljoint again.
wildwillydriver
01-12-2011, 11:13 AM
Stupid question and has prob been answered
My 511 rod ends keep coming off
which ones are recommended as a replacement
I see loads of 511/502's going round with white rod ends
What are they?
Thanks for any help
Dez
White rod ends, can be the one below?
http://rclazy.com/shop/accessories/losi-super-duty-ball-cups-natural-losa6015/
Bye.
WWD
:)
mattybucks
01-12-2011, 11:29 AM
You can use losi ball cups but you need to replace the ball joints. I now use the hardend tamiya ball joints with the grey tamiya ball cups.
bender
01-12-2011, 04:09 PM
I had both a tamiya 501x and Durga and rather than replacing the rod ends i replaced the metal ball studs with the Kyosho ones off the Ultima/Lazer.
These seem a very tiny bit bigger and what it did was take out all the slop and stop the standard rod ends from popping off :D
Worked great, and cheaper than replacing both rode ends and ball studs, which you'll have to do if u switch over to Losi 4.3mm size
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.