PDA

View Full Version : There is NO WAY...


GeordieBoyKel
15-12-2011, 11:11 PM
This diff is going in place with this belt on..! WTF! Sorry....

Cardnim
15-12-2011, 11:28 PM
Err, yes there is.
Not sure what way youve got it set up, but if correct then just...
- put the diff into the belt
- ensure belt is sitting on pulley and diff teeth correctly
- set diff into recess on lower diff housing
- ensure both eccentric bearings are llined up the same.


Et voila; Bob's your uncle, Agnus is your aunt and your diff is in!

bigred5765
15-12-2011, 11:29 PM
wrong belt back in front etc

Cardnim
15-12-2011, 11:31 PM
See Page 9 , step 14B in the SX2 manual if you are still unsure.
Its quite clear there.

If you dont have the manual you can get it here:
SX2 MANUAL (http://www.racing-cars.com/images/Technical_Info/Schumacher/Old%20Cars/CAT%20SX2/Instruction%20Manual/CAT_SX2_manual.pdf)

Cardnim
15-12-2011, 11:32 PM
wrong belt front in back or back in front etc

Good thinking Carl, that could be it.
Also, once, I had the rear belt going round the spur gear layshaft as well - this made it impossible to get the diff to seat properly.
Maybe something to check? :confused:

bigred5765
15-12-2011, 11:37 PM
yeh thats the other one make sure the belt is above the layshaft

GeordieBoyKel
16-12-2011, 01:09 AM
Good thinking Carl, that could be it.
Also, once, I had the rear belt going round the spur gear layshaft as well - this made it impossible to get the diff to seat properly.
Maybe something to check? :confused:

10 Points for the man... How many mistakes can I make on this build man!

Im sure I will get there in the end.

Going to have another look at the front diff also as it is a little tight now for some reason. It was fine when it was out...

Kelvin

bigred5765
16-12-2011, 01:15 AM
as long as its not notchy tight is ok infact tight is good

GeordieBoyKel
16-12-2011, 01:21 AM
Really?

The rear was the same so I adjusted it, but if you say that tight is good then I will put it back to how it was.

GeordieBoyKel
16-12-2011, 01:23 AM
Can I just say, It Looks So Small! :)