View Full Version : DEX210 Motor Position Changes?
av4625
28-12-2011, 08:05 PM
Is it complecated to change the dex210's motor from mid motor 3 gear to mid motor 4 gear as those are the 2 id b using if i get 1 and was wondering if it is hard to change or is it a quick job?
hotrodchris
28-12-2011, 08:20 PM
Back end rebuild not too major as most will do as maintenance after a meeting or two but not something that i would do track side
paulc
28-12-2011, 10:35 PM
Swapped mine from mid motor 4 gear to rear motor 4 gear in about 30-45 minutes ish including electrics so if your just adding or taking a gear out probably about a 15 minute job
But you did have loads of weetabix that morning though paul!:lol:
av4625
28-12-2011, 11:40 PM
Swapped mine from mid motor 4 gear to rear motor 4 gear in about 30-45 minutes ish including electrics so if your just adding or taking a gear out probably about a 15 minute job
but do you not need to turn the whole motor and mechanism around the other way?
paulc
29-12-2011, 10:29 AM
but do you not need to turn the whole motor and mechanism around the other way?
No only the motor plate/slipper assembly needs to be swapped from one side to the other but you'll have the gearbox in bits anyway for adding or taking a gear out. Instruction books on the Durango website take alook at that
paulc
29-12-2011, 10:30 AM
But you did have loads of weetabix that morning though paul!:lol:
LOL...
hottuna
30-12-2011, 04:50 PM
7-10 min job from 3RM to 4MM as I have 2 complete gearboxes in these configurations
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.