PDA

View Full Version : 24.3mm LIPO in DEX410


GML
15-01-2012, 11:59 AM
I've just finished a V3 and I want to test it with SMC lipo battery. They are too tall for the middle hole of the battery holder and I have play with the upper hole wich is for 25mm batteries.

I can't find any pic with these lipos and I want to know what's the best way to maintain it correctly (with some plastic card or other)

Or is this play normal for the flex of the chassis ??

Bugle
15-01-2012, 01:16 PM
If you've got any chassis protection tape you could put it onto the chassis under the battery to take up some of the space, stop the batteries rubbing sand/dirt/small rocks into the chassis at the same time.

HyperFX
15-01-2012, 09:59 PM
Don't put spacers below your batts. Only attach the spacer on the top of the batts that need it. That way, you don't raise the CoG, and you don't need to remove spacers from the chassis for the 25.1 batts. :thumbsup:

GML
06-03-2012, 02:48 PM
Here is my solution :

A 0.5mm Plasticard Evergreen (I used to cut Tamiya 1/24 number plates with it)

http://img140.imageshack.us/img140/6423/img0255nl.jpg