View Full Version : pinion gear help !
bod405
05-04-2008, 02:33 PM
hi there im after some advice (again)....ive got my dbo1 and ive got a new motor for it, its a modified 12x2 reedy any ideas what size pinion i should be using to be honest any advice on fitting this motor would be much appreciated
A.J. Gee
05-04-2008, 04:53 PM
The supplied 17T pinion would be your best bet. The 23T pinion would be geared too high in my opinion. I would say anywhere between 17 and 20 would be good.
rcluke
13-04-2008, 03:19 PM
getting the pinion size right is critical, too big and you will kill the motor, too small and you will kill the motor.
if i was you, buy a large selection of pinions and do a few minutes driving using each and check the temperature.
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.