View Full Version : SV2 issues
trr061984
22-04-2012, 03:42 PM
Just got the SV2 built over the last week and a half. Not really got many problems with it but I do have a couple of questions.
First is, how is the lipo going to be held in? The top deck looks ok but after a big crash I can see the lipo coming loose. I suppose I need to velcro the bottom of the lipos as well?
Second, the top deck is a little irritating for getting the lipo in and out off. Do I have to keep unscrewing the four screws every time?
Cheers.
jonathan may
22-04-2012, 04:33 PM
i have had no problems with the lipos falling out
i am using body clips to hold the top deck on but you can undo the 2 rear screws and slide the cells out the side
mark christopher
22-04-2012, 04:45 PM
Just got the SV2 built over the last week and a half. Not really got many problems with it but I do have a couple of questions.
First is, how is the lipo going to be held in? The top deck looks ok but after a big crash I can see the lipo coming loose. I suppose I need to velcro the bottom of the lipos as well?
Second, the top deck is a little irritating for getting the lipo in and out off. Do I have to keep unscrewing the four screws every time?
Cheers.
how thick are you lipos?
Swiss
23-04-2012, 03:53 PM
I don't put the back screws in. Just put a little foam under the strap as well. Then it just a case of removing the two front screws and pulling the lipo's out.
Paul
trr061984
24-04-2012, 12:01 AM
I don't put the back screws in. Just put a little foam under the strap as well. Then it just a case of removing the two front screws and pulling the lipo's out.
Paul
Ok, thanks for the advice. We'll see how we go this week at racing.
trr061984
29-04-2012, 03:14 PM
how thick are you lipos?
About 2cm?
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.