To mark penney
 

Can you post your setup used this week-end for your C4.1 and B44.1?
Great thanks for answer:thumbsup:

pm him, noreargrip is his user name.:thumbsup:

I sure can...I'll write up the set ups and attempt to put them on tomorrow night...

set ups
 

cant get set up sheets to upload to oople...files too big and i dont know how to alter them so ill just write them out..
centro rear

no.1 piston,30wt oil green spring and one .030 limiter
2nd hole from inside on shock tower
inside on wishbone.
camber link inside and top hole on shock tower
middle hole on plastic hubs
2 degree anti squat
medium wheelbase
yellow minispikes outer and inner row spikes cut off..sch med foams
ride height 20mm
centro front

no.2 piston,40wt oil,silver spring,two .030 limiters
inside on shock tower
outside on wishbone
camber link inside on tower,1 washer
inside on hub
30degree caster blocks.
fastrax front brass bulkhead.no further weight on this..
rudebits brass under steering rack weight.
20g in front of servo..
yellow cut stagger sch tyres sch med foams
ride height :wishbones just below level
b44.1 front

no. 2 piston,37.5wt oil,silver spring,one .030 limiter
shocks: inside on tower
outside on wishbone
camber link inside with one washer on ball stud
link outside on hub
ride height-just below drive shaft level
ackerman in the back position
sch minispikes yellow,outside and inside rows cut off sch med foams

rear

no2 piston,25wt oil,green spring,one .030 limiter
shocks:inner hole on tower,
inner hole on wishbone
camber link:outside on bulkhead,one washer
2nd from inside on hub block A
silver roll bar
one washer on anti squat plate.
medium wheelbase
60g rudebits brass centre weights:thumbsup:

hope this helps...contact me if any more info needed.

big thank you to Mark for answering. It's very nice and very fast too.:thumbsup::thumbsup: