orion r10 problem
 

i have a 90a , 120a and 160a . i can use the 90 and 160 with the programmer but 120 wont work with it . im running the lastest software and tried all the firmwares but it doesnt work.

anybodys help is much welcome

Does it work when connected to a pc?
If so try resetting it to your Tranny again, had this issue with one of mine had to set the esc and tranny twice to get the program card to work!

yea i can adjust and save settings through the pc . ok i will try that cheers

Ok i tried it 2day 4-5 times but cannot get working with the programmer

Did you tried to unplug the motor sensor? Some motors seem to interfer with the programmer.

i always use the sensor wire plug from the motor . so the motor isnt connected